News Feed (View All Updates)
JesperChristophersen has posted in Brake master cylinder bleeding Mondeo MK4 2011 2,0TDCI 163hp in Drivetrain (Mk4 Mondeo).
Today, 11:21 AM
inventiv has started Clutch Master Cylinder Replacement – Wet Shoe Problem – How to fix it… in Mechanical (Focus Mk1) .
Today, 10:41 AM
TreborB has posted in AWD front differential , noise and strange "lockup" in Ford Transit / Tourneo / Connect Forum .
Today, 08:25 AM
ST56 has posted in AWD front differential , noise and strange "lockup" in Ford Transit / Tourneo / Connect Forum .
Yesterday, 11:33 PM
ST56 has posted in Ford Mondeo MK3 pulling left despite 3 '4-wheel alignments' and have vibration in Suspension / Wheels / Brakes / Steering (Mk3 Mondeo).
Yesterday, 11:17 PM
tomskys has posted in Ford Mondeo MK3 pulling left despite 3 '4-wheel alignments' and have vibration in Suspension / Wheels / Brakes / Steering (Mk3 Mondeo).
Yesterday, 08:58 PM
Ford Kuga Titanium
Posted 11 October 2019 - 07:56 PM
First job that needs doing is :
Disassemble the rear to fit a new towbar !
I went for a swan neck with a dedicated 13 pin electrics,
Bumper back on !
It’s a straightforward job to do!, other than the little black clips for the mud flaps !
All back together and check all the lights and rear park sensors !,
The 13 pin socket is fitted, but I’ll connect them tomorrow!.
Posted 01 February 2020 - 03:46 PM
Just done a service, oil & filter, fuel filter & air filter.
No difference to servicing the Mondeo ! Other than the fuel filter being under the bonnet 😎.
I didn’t get much of a service history with the car,
So I’ve just changed the the auto transmission oil & filter !.
The oil looks dirty in the bucket !
But it wasn’t too bad!, so has been changed at some point !
The filter was black, so it’s doing it’s job.
It was a genuine ford one too !.
New tyres next !
Edited by Ste L, 01 February 2020 - 03:48 PM.
Posted 08 May 2020 - 05:45 PM
New tyres are on!
Thought I would give the calipers a clean & paint !
They were not to bad, just light surface rust
Quick clean & rub down, then 2 coats of hammerite Matt silver paint !
Forgot to take a picture before I put the wheels back on 🙄
Next will be new timing belt & water pump,
Then get the wheels refurbished!
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users